CCNA Exploration 4.0, CCNA 640-802, CCNA Answers, CCNA Blog

CCNA 3 Final 2012 Exam Answers Updated July 2012

admin — Fri, 29 Jun 2012 08:12:42 +0000

This article contains all three sets of questions. 1. Refer to the exhibit. After entering the commands in the exhibit, the administrator receives a “password required, but none set” message when attempting to connect to S1. What is the problem? The enable secret password was not set. S1 does not have login configured on [...]

CCNA 2 Final 2012 Exam Answers – V3

admin — Fri, 29 Jun 2012 08:07:32 +0000

1. Refer to the routing table shown in the exhibit. What is the meaning of the highlighted value 192? It is the value assigned by the Dijkstra algorithm that designates the number of hops in the network. It is the value used by the DUAL algorithm to determine the bandwidth for the link. It is [...]

CCNA 2 Final 2012 Exam Answers – V2

admin — Fri, 29 Jun 2012 08:05:58 +0000

1. Which of the following are required when adding a network to the OSPF routing process configuration? (Choose three.) network address loopback address autonomous system number subnet mask wildcard mask area ID 2. Which of the following are primary functions of a router? (Choose two.) packet switching microsegmentation domain name resolution path selection flow control [...]

CCNA 2 Final 2012 Exam Answers – V1

admin — Fri, 29 Jun 2012 08:02:41 +0000

1. Which of the following are required when adding a network to the OSPF routing process configuration? network address loopback address autonomous system number subnet mask wildcard mask area ID 2. Which of the following are primary functions of a router? (Choose two.) packet switching microsegmentation domain name resolution path selection flow control 3. Refer to [...]

CCNA 1 Final 2012 Exam Answers – eg.3

admin — Fri, 29 Jun 2012 08:00:48 +0000

1. When must a router serial interface be configured with the clock rate command? when the interface is functioning as a DTE device when the interface timers have been cleared when the connected DTE device is shut down when the interface is functioning as a DCE device 2. Refer to the exhibit. A network technician [...]

CCNA 1 Final 2012 Exam Answers – eg.2

admin — Fri, 29 Jun 2012 07:57:24 +0000

CCNA 1 Final 2012 Exam Answers – eg.1

admin — Fri, 29 Jun 2012 07:48:29 +0000

Which of the following are the address ranges of the private IP addresses? (Choose three.) 10.0.0.0 to 10.255.255.255 200.100.50.0 to 200.100.25.255 150.150.0.0 to 150.150.255.255 172.16.0.0 to 172.31.255.255 192.168.0.0 to 192.168.255.255 127.16.0.0 to 127.31.255.255 Which two functions of the OSI model occur at layer two? (Choose two.) physical addressing encoding routing cabling media access control Refer [...]

Packet Tracer Version 5.3.3 Software Downloads Update 08.02.2012

admin — Wed, 08 Feb 2012 10:58:44 +0000

Packet Tracer Version 5.3.3 Software Downloads Packet Tracer version 5.3.3 is a maintenance release that fixes functional and technical issues in the previous versions. It replaces Packet Tracer version 5.3.2. Packet Tracer 5.3.3 supports activities authored in Packet Tracer 4.x, 5.0.x, 5.1.x, 5.2.x, and 5.3.x. Please note that the last two courses of the CCNA [...]

ccna 4 final 2012

admin — Mon, 12 Dec 2011 05:53:17 +0000

ccna 4 final 2012 (95%) EWAN Final Exam – CCNA Exploration: Accessing the WAN (Version 4.0) 1 Refer to the exhibit. Communication between two peers has failed. Based on the output that is shown, what is the most likely cause? interface reset unplugged cable improper LMI type PPP negotiation failure 2 Refer to the exhibit. [...]

If you can not access to ccna4u.org

admin — Sun, 11 Dec 2011 05:49:37 +0000

Website ccna4u.org 40,000 visits per day, so sometimes you do not access to website because website overload. If you can not access to ccna4u.org please visit: www.ccna4u.net www.ccna4u.biz www.ccnafinal.net www.testccna.com Thank you! Twitter: twitter.com/ccna buy viagra